Then set an IP address which will be on the hypervisor network to reach the cluster and the nodes. Run the script set_foundation_ip_address.Ĭhoose Device configuration. Once the Foundation VM is started and you are authenticated to the system, you should get the following desktop. An additional IP is required for the cluster address. It is recommended that the CVM network and the Hypervisor network were on the same subnet. You need also the lastest AOS release (5.1.3 at the time of writing this topic) and the VMware ESXi 6.5u1 ISO. In this way nothing will trouble the deployment. I heavily recommend you to bring a simple switch (no manageable, 8 ports) to plug your laptop and Nutanix nodes. This VM should be run on your laptop so you need a hypervisor which can run this VM such as VMware Workstation or VirtualBox. This is a VM provided by Nutanix which contains tools to re-image node. To re-image Nutanix nodes, you need Nutanix foundation that you can download from Nutanix portal. I promise, I’ll do better next time 🙂 Requirements If you have a branded block (such as Dell), the procedure may change especially about network adapter to plug. The following procedure regards Nutanix blocks. In this topic we’ll see how to re-image Nutanix nodes to VMware ESXi So, you have to re-image the Nutanix nodes to the wanted hypervisor (Hyper-V, ESXi or KVM). Usually Nutanix blocks are shipped with nodes imaged on AHV. I wanted to share with you how to re-image the Nutanix nodes to VMware ESXi. Using PuTTY or a Linux console, SSH into the host IP address that you assigned above, and then log in using the username root and the password used during the installation.This week I deployed a Nutanix cluster based on VMware ESXi 6.5u1. Verify that the host IP address appears correctly. Press Esc two times to return to the main menu. Enable them, if necessary: select each respectively, and then press Enter. Verify that the ESXi Shell and SSH are enabled. In the System Customization pane, select Troubleshooting options, and then press Enter. Press Esc, and then when prompted to apply changes and restart the management network, press Y. Press the spacebar, and then enter the following IP addresses. Navigate to IPv4 Configuration, and then select Set static IPv4 address and network configuration. Select Configure Management Network VLAN (optional), and then assign a VLAN ID. Press F2, and then log in to the localhost (root) using the password used during installation. Log in to the node BMC, and then click Remote Control Launch KVM (Java). Install ESXi 7.0 from the downloaded ISO. Verify that Java 8 update 241 is installed on the service laptop.Download the ESXi 7.0 ISO package to the service laptop.

Install vmware esxi on laptop