mac wireless keyboard not working after battery change

now the well is open and you can push the battery back down the original way it came in. slowly push keep pushing up the battery until the spring and holder pop off. if the screwdriver is not long after the battery moved up, put another old battery in the well to give you an extension.ħ. using the screwdriver with one or two forceful pushes, push hard and the slip ring will give way the battery will move up towards the opening over were the plastic bag is at. put a PLASTIC BAG over the opening, because there is a spring that will pop out.Ħ. tape the tip of the screw driver and stick the inside the battery well.you will use the screwdrive to push up the battery. NOTE*** be careful and be attentive to the keyboard wire as you perform the next stepsĥ.once you see the connection take it off with your nail or screw driverĤ.slide out circuit board, and using the some tape, tape down the circuit wire and battery wire. slide slowly, the battery connection is attached.

remove tape, unclip the plastic lock and pull circuit wire from the back of the board ( similar to Ipod,Iphone connection)Īnd push the circuit board towards the button you use to power up the keyboard. remove the first screw, 2a, bend back slowly the soldered part that you just removed the screw from, 2b, unscrew the post.ģ.there is a piece of tape the is covering the wiring lock to the circuit board. there is only 2 screws holding down the electronic board. any type of tape, to tape down the wires.Ģ.remove plastic cover it will pop off once glue is removed. Get the longest screwdriver you can find, that can touch the battery and still have length showing once you put the screwdriver in the battery well. I have the tool, but the teeth were not long enough to reach the holes on the lock ring. Its called a lock ring too you can find in a engine repair shop.

Mac wireless keyboard not working after battery change